Εισάγετε μια λέξη ή φράση σε οποιαδήποτε γλώσσα 👆
Γλώσσα:
Μετάφραση και ανάλυση λέξεων από την τεχνητή νοημοσύνη ChatGPT
Σε αυτήν τη σελίδα μπορείτε να λάβετε μια λεπτομερή ανάλυση μιας λέξης ή μιας φράσης, η οποία δημιουργήθηκε χρησιμοποιώντας το ChatGPT, την καλύτερη τεχνολογία τεχνητής νοημοσύνης μέχρι σήμερα:
- πώς χρησιμοποιείται η λέξη
- συχνότητα χρήσης
- χρησιμοποιείται πιο συχνά στον προφορικό ή γραπτό λόγο
- επιλογές μετάφρασης λέξεων
- παραδείγματα χρήσης (πολλές φράσεις με μετάφραση)
- ετυμολογία
Τι (ποιος) είναι Data Terminal Ready - ορισμός
Data Terminal Ready
CONTROL SIGNAL IN RS-232 SERIAL COMMUNICATIONS
Data terminal ready
<communications> (DTR) The wire in a full RS-232 connection
that tells the Data Communication Equipment (DCE, typically
a modem) that the Data Terminal Equipment (DTE, typically
a computer or terminal) is ready to transmit and receive
data.
(2000-04-05)
Data Terminal Ready
CONTROL SIGNAL IN RS-232 SERIAL COMMUNICATIONS
Data terminal ready
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
Data Terminal Equipment
COMMUNICATIONS SYSTEM EQUIPMENT
Data Terminal Equipment; Data terminating equipment; Datenendeinrichtung; DTE (telecommunication); DEE (telecommunication)
<communications, hardware> (DTE) A device which acts as the
source and/or destination of data and which controls the
communication channel. DTE includes terminals, computers,
protocol converters, and multiplexors.
DTE is usually connected via an EIA-232 serial line to
Data Communication Equipment (DCE), typically a modem. It
is necessary to distinguish these two types of device because
their connectors must be wired differently if a
"straight-through" cable (pin 1 to pin 1, pin 2 to pin 2 etc.)
is to be used. DTE should have a male connector and should
transmit on pin three and receive on pin two. It is a curious
fact that many modems are actually "DTE" according to the
original standard.
(1995-02-28)
Βικιπαίδεια
Data Terminal Ready
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
